Project Description

Main Project Image
The project owner hasn't added main project image yet.
Project description
SPECIFICATIONS - User selectable charge rate -- 100mA or 500mA - LED shows charging state; it turns on when charging is complete COMPONENTS - C1 and C2 are ceramic multi-layer capacitors, but they can be replaced with electrolytics for better capacitance (ceramic voltage coefficient means that they will only be 3-3.5 uF instead of 4.7 at 5V). - J1 (3-way male header) should be shorted between pin 2 & 3 for 100mA of charging current and 1 & 2 for 500mA of current. - R3 and R2 determine the charge current depending on which of the two is selected from J1. The equation for charge current can be found in the MCP73831 datasheet. USAGE - You can plug the charger into a 5V USB port or solder wires to the exposed USB pads for power. - Setting the charge current selection jumper towards the blue blob on the header silkscreen sets it to 500mA. - Removing the charge current selection jumper terminates the current charge (if one is active).
Gallery
The project owner hasn't added any images yet.

Design Files

Embed Code
Component (12)
Qty
Description
S2B-PH-SM4-TB(LF)(SN)

J2

1
S2B-PH-SM4-TB(LF)(SN)
Capacitor

C2

1
Generic Capacitor (4.7uF)
Resistor

R2

1
Generic Resistor (2k)
Resistor

R4

1
Generic Resistor (470r)

Export Design Data

Open JSON Format
All model data in Upverter's Open JSON export format (more info)
Gerber Format (RS-274X extended)
CAD to CAM transfer instructions (more info)
NC Drill (Excellon)
NC drill and route machine instructions (more info)
XYRS
X-Y, rotation and side data for Pick and Place assembly (CSV)
PADS Layout Netlist
Export your schematic into a third-party layout tool
Dimension Drawing
Export the board outline, holes, and rulers
High-Res Schematic PNG
High resolution image form
3D Model (Step)
3D model of the board and components