Project Description

Main Project Image
The project owner hasn't added main project image yet.
Project description
It's blue! It's skinny! It's the Arduino Pro! SparkFun's minimal design approach to Arduino. This is a 5V Arduino running the 20MHz bootloader.The power switch was moved to the side of the board (good idea Limor!) to allow control when a shield is attached. Please note: The right-angle power switch is fragile. We're working on making the switch stronger. For now, please be gentle. This is a 20MHz board. This will get you maximum speed out of the ATmega328, but the current version of Arduino does not support the ATmega328 running at 20MHz. You can use the 'Arduino Duemilanove w/ 328' setting, but the timing and delays will assume the board is at 16MHz, so everything will run faster and may mess up timing limitations. Arduino Pro does not come with connectors populated so that you can solder in any connector or wire with any orientation you need. We recommend first time Arduino users start with the Duemilanove. It's a great board that will get you up and running quickly. The Arduino Pro series is meant for advanced users that understand the limitations of system voltage (5V), lack of connectors, and USB off board. We wanted Arduino Pro to be low profile. The DC power jack footprint is available, but not populated. We recommend running the board with a LiPo battery for better portability. We really wanted to minimize the cost of an Arduino. The Arduino Pro is like the Arduino Duemilanove (same pin out) but to keep the cost low, we used all SMD components, made it two layer, etc. This board connects directly to the FTDI Basic Breakout board and supports auto-reset. The Arduino Pro also works with the FTDI cable but the FTDI cable does not bring out the DTR pin so the auto-reset feature will not work. Project description, more information and ordering can be found at https://www.sparkfun.com/products/8789 Arduino Pro Hompage: http://www.arduino.cc/en/Main/ArduinoBoardPro Getting Started: http://www.arduino.cc/en/Guide/ArduinoPro
Gallery
The project owner hasn't added any images yet.

Design Files

Embed Code
Component (26)
Qty
Description
SparkFun:POWER_JACK:PTH

JP4

1
SparkFun:POWER_JACK:PTH
SparkFun:CAP:0402

C10, C3, C1, C2

4
SparkFun:CAP:0402
SparkFun:FRAME-LETTER:

FRAME1

1
SparkFun:FRAME-LETTER:
SparkFun:GND:

GND24, GND25, GND26, GND28, GND6, GND3, GND5, GND1, GND7, GND8, GND29, GND30, GND32, GND10, GND11, GND4, GND9

17
SparkFun:GND:

Export Design Data

Open JSON Format
All model data in Upverter's Open JSON export format (more info)
Gerber Format (RS-274X extended)
CAD to CAM transfer instructions (more info)
NC Drill (Excellon)
NC drill and route machine instructions (more info)
XYRS
X-Y, rotation and side data for Pick and Place assembly (CSV)
PADS Layout Netlist
Export your schematic into a third-party layout tool
Dimension Drawing
Export the board outline, holes, and rulers
High-Res Schematic PNG
High resolution image form
3D Model (Step)
3D model of the board and components