The Arduino Mega now has its very own prototyping shield! The MegaShield mates with the Arduino Mega board and gives the user a prototyping area, two general LEDs, and, most important of all, the Arduino Mega reset switch is brought to the top level. The shield also works with our small breadboards if you don't want to solder to the prototyping area. This comes in kit form and must be soldered together by the end user. Please note - we do not ship assembly instructions! All soldering is through-hole (relatively easy) but always check your component orientation before soldering! Project description, more information and ordering can be found at https://www.sparkfun.com/products/9346 8-pin Arduino Stackable Header: http://www.sparkfun.com/commerce/product_info.php?products_id=9279 Bright 5mm Green LED: http://www.sparkfun.com/commerce/product_info.php?products_id=8285 Bright 5mm Red LED: http://www.sparkfun.com/commerce/product_info.php?products_id=528 330 Ohm resistors: http://www.sparkfun.com/commerce/product_info.php?products_id=8377 Momentary push button: http://www.sparkfun.com/commerce/product_info.php?products_id=97 10k resistor: http://www.sparkfun.com/commerce/product_info.php?products_id=8374 Protoshield Schematic: http://www.sparkfun.com/datasheets/DevTools/Arduino/Mega_Shield-v12.pdf Assembly Tutorial: http://www.atomicsalad.com/archive/2010/02/07/tutorial_assembling_the_sparkfun_megashield.php Arduino Home Page: http://arduino.berlios.de/