The serial enabled LCD allows you to control a parallel based LCD over a single-wire serial interface. Included in this product is an amber on black 16x2 LCD connected to our serial backpack. The backpack, based around a PIC16LF88, takes a TTL serial input and prints the characters it receives onto the LCD. The installed firmware allows for a number of special commands so you can clear the screen, adjust the backlight brightness, turn the display on/off, and more. Communication with SerLCD requires 3.3V TTL serial at a default baud rate of 9600bps (8-N-1). You can adjust the baud to any standard rate between 2400 and 38400bps. The power, ground and RX pins are all broken out to a 3.5mm pitch screw terminal. SerLCD has the ability to dim the backlight to conserve power if needed. There is also a potentiometer on the backpack to adjust the contrast. Note: Though the silkscreen may say '5V', this is a 3.3v Serial LCD. Connect to a 3.3v power source. Project description, more information and ordering can be found at https://www.sparkfun.com/products/9069 SerLCD v2.5 Datasheet: http://www.sparkfun.com/datasheets/LCD/SerLCD_V2_5.PDF Pin Assignment: http://www.sparkfun.com/datasheets/LCD/SerLCD-PinAssignment.pdf Quickstart Guide: https://www.sparkfun.com/tutorials/246 Firmware: http://dlnmh9ip6v2uc.cloudfront.net/datasheets/LCD/Monochrome/serlcd-v2_7_2line_10MHz.zip