4x4 Driver Shield
Project Description
Main Project Image
The project owner hasn't added main project image yet.
Project description
The 4x4 Driver Shield is designed to enable users to switch DC loads up to 5A at up to 30V with no heat-sinking. It is ideal for such applications as driving solenoids, relays, and small DC motors. It uses International Rectifier IPS6044 quad channel fully-protected high side MOSFET switches, which include over-temp, over-current, and under-voltage protection. The high-side topology is safer in many applications than the more common low-side topology because a short to ground cannot energize the circuit while the switch is turned off, as it can with a low-side switch. This shield can also be used to drive four unipolar stepper motors.
Project description, more information and ordering can be found at https://www.sparkfun.com/products/11352
User Manual: http://dlnmh9ip6v2uc.cloudfront.net/datasheets/Dev/Arduino/Shields/4x4-Driver-Shield-manual.pdf
Arduino Library: https://github.com/logos-electromechanical/shiftStepper
Product Video: http://youtu.be/YgKS333HJ-4?t=12s
Gallery
The project owner hasn't added any images yet.
Design Files
Embed Code
Component (13)
Qty
Description
supply1:+5V:
P+1, P+2, P+3
3
supply1:+5V:
supply1:GND:
GND1, GND3, GND2, GND8, GND9, GND23, GND24, GND25, GND4, GND5, GND6, GND7, GND10
13
supply1:GND:
logos-headers:F25VP-S:
X2
1
logos-headers:F25VP-S:
arduino-shields:2009:
SHIELD1
1
arduino-shields:2009:
